Editing 80-series (section)

=New Antennas=
*REC-1N4A = 1-Way 433Mhz antenna.<br>
**Marked with Omega & xASK logo<br>
*REC-2N4A = 2-Way 433Mhz antenna.<br>
**Marked with TILT 3D, ECHO & xASK logo<br>
**Built in tilt sensor<br>
*REC-1N9A = 1-Way 900Mhz antenna.<br>
**Marked with Omega & xSST logo<br>
*REC-2N9A = 2-Way 900Mhz antenna.<br>
**Marked with TILT 3D, ECHO & xSST logo<br>
**Built in tilt sensor<br>
<br>
Tilt sensor programming:<br>
-Tilt sensor is Off by deafault<br>
Step 1: Hold the programming button for 5 seconds.<br>
- At 2 seconds, the system will enter valet mode.<br>
- After 5 seconds, the status LED will flash rapidly, release the button. The system will exit valet mode and stay in tilt/feature programming mode.<br>
Step 2: Tap the programming button equal to the desired feature number:<br>
Feature #1: Tilt trigger sensitivity<br>
- The status LED will flash equal to the selection, pause then repeat.<br>
Step 3: Tap the programming button equal to the desiredfeature number:<br>
1 = OFF, 2 = 1 Degrees, 3 = 2 Degrees, 4 = 3 Degrees 5= 4 degrees<br>
- The status LED will flash equal to the selection, pause then repeat.<br>
Step 4: Tap the START button on the remote to confirm.<br>
- The status LED will turn on for 1 second to confirm.<br>
- The status LED will flash to indicate the current feature setting, pause, then repeat.<br>
Step 5: Tap the START button on the remote to confirm.<br>
- The status LED will turn on for 1 second to confirm.<br>
- The module will return to step 02.<br>
TO EXIT: Hold the button for 5 seconds or wait 30 seconds.<br>
<br>
REC-2NxA Full Reset:<br>
Step 1: Unplug the harness from the antenna module.<br>
Step 2: Hold the programming button. <br>
Step 3: Plug in the harness to the antenna module. <br>
Step 4: Continue holding the programming button for 5 seconds. Release when the status LED turns on solid for 1 second. <br>
The module is now reset to default feature settings.<br>




==Good to know stuff/DEV notes==
Antenna LED operation is 100% data driven, some LED sequences like ATV will continue until the count is completed no mater what the ignition status is<br>
Programmable analog LED outputs and antenna LED timing will not be 100% synced.<br>
Hood no longer acts as Door for MT mode, all system have dedicated door trigger<br>
Fortin EVO's are not officially supported, BUT 1-way IVU will program to Fortin. 2-way will not program due to required "enter programming" data message not being sent by EVO at this time<br>