80-series

New 80 Series Features

New Programmable Feature Structure
Features are now broken into 6 Banks
1. RS Options
2. Convenience Options
3. Security Options
4. System Behaviors
5. Output Config
6. Input Config
Enter programming with Ignition On/Off and valet 5x

System will confirm, with 2 chirps

Ignition back On IF brake requires ignition On for operation

Use prog button to select desired feature bank

System will respond with chirps to correspond to selected bank number

Chirps will repeat after ~2 seconds delay

Press brake to confirm selection

System will respond with 1x chirp

Use prog button to select desired feature

System will respond with chirps to correspond to selected feature number

Chirps will repeat after ~2 seconds delay

Press brake to confirm selection

System will respond with chirps to indicate current option setting of selected feature

Use prog button to select desired option within feature

System will respond with chirps to correspond to selected option

Press brake to confirm selection

System will respond with 1x chirp and return to feature selection in current bank

Pressing Brake again will go back to the bank selection option

Feature Reset - Turn the ignition "on" then "off", immediately press the valet button 5 times. After long siren chirp/horn honk press and hold the Brake Pedal for >2 seconds. The system will chirp once and exit programming with all features set to OEM defaults.

New 80 Series Hardware

Non-blade control module (AL-80 / RS-80)
Same 6-pin main harness pinout as 70-seroes with adjusted wire gauges

Red/White is now Red/Black

Includes single analog sensor port and door triggers in sub harness
New 4-pin harness w/ (+/-)P/L, Ground, and Siren
New 12-pin harness with 22AWG wires for all inputs and low current outputs
New antenna port is not 4-pin iData connector on side of module
Door lock port, Green & Black data ports, and Red RS output ports are all carryover from 70-series
Blade control Module (AL-80-B / RS-80-B)
Same 6-pin main harness pinout as 70-seroes with adjusted wire gauges

Red/White is now Red/Black

Includes two analog sensor ports that are now independent zones(1 - White / 1-Yellow)
New 4-pin harness w/ (+/-)P/L, Ground, and Siren
New 12-pin harness with 22AWG wires for all inputs and low current outputs
New 6-pin harness with 18AWG wires for Horn/Light flash relays input/outputs
New antenna port is not 4-pin iData connector on side of module
Door lock port, Green & Black data ports, Red & Blue RS output ports, and Blade connector are all carryover from 70-series