80-series

New 80 Series Features

New Programmable Feature Structure
Features are now broken into 6 Banks
1. RS Options
2. Convenience Options
3. Security Options
4. System Behaviors
5. Output Config
6. Input Config
Programming now uses Prog button and Brake to select banks, feature, and options.
Enter programming with Ignition On/Off and valet 5x

System will confirm, with 2 chirps

Ignition back On IF brake requires ignition On for operation

Use prog button to select desired feature bank

System will respond with chirps to correspond to selected bank number

Chirps will repeat after ~2 seconds delay

Press brake to confirm selection

System will respond with 1x chirp

Use prog button to select desired feature

System will respond with chirps to correspond to selected feature number

Chirps will repeat after ~2 seconds delay

Press brake to confirm selection

System will respond with chirps to indicate current option setting of selected feature

Use prog button to select desired option within feature

System will respond with chirps to correspond to selected option

Press brake to confirm selection

System will respond with 1x chirp and return to feature selection in current bank

Pressing Brake again will go back to the bank selection option

Feature Reset - Turn the ignition "on" then "off", immediately press the valet button 5 times. After long siren chirp/horn honk press and hold the Brake Pedal for >2 seconds. The system will chirp once and exit programming with all features set to OEM defaults.

New 80 Series Hardware

Non-blade control module (AL-80 / RS-80)

• Same 6-pin main harness pinout as 70-seroes with adjusted wire gauges
  
  • Red/White is now Red/Black
    
• Includes single analog sensor port and door triggers in sub harness
  
• New 4-pin harness w/ (+/-)P/L, Ground, and Siren
  
• New 12-pin harness with 22AWG wires for all inputs and low current outputs
  
• New antenna port is not 4-pin iData connector on side of module
  
• Door lock port, Green & Black data ports, and Red RS output ports are all carryover from 70-series
  

Blade control Module (AL-80-B / RS-80-B)

• Same 6-pin main harness pinout as 70-seroes with adjusted wire gauges
  
  • Red/White is now Red/Black
    
• Includes two analog sensor ports that are now independent zones (1 - White / 1-Yellow)
  
• New 4-pin harness w/ (+/-)P/L, Ground, and Siren
  
• New 12-pin harness with 22AWG wires for all inputs and low current outputs
  
• New 6-pin harness with 18AWG wires for Horn/Light flash relays input/outputs
  
• New antenna port is not 4-pin iData connector on side of module
  
• Door lock port, Green & Black data ports, Red & Blue RS output ports, and Blade connector are all carryover from 70-series
  

New Remotes

119-03 - One button 1-way in carryover case from 70-seroes

New xASK logo replaces x433

CR-2032 battery

1420-03 - Four button 1-way with new case design

New xASK logo replaces x433

Plastic case with metal trim ring

Snap together case, no screws

CR-2032 battery

1423-03 - Four button 1-way in carryover all plastic case from 70-seroes

New xASK logo replaces x433

CR-2032 battery

1514-03 - Five button 2-way with new case and screen layout

New xASK logo replaces x433

USB-C charge port

USB-C firmware update capability