80-series
New 80 Series Features
New Programmable Feature Structure
Features are now broken into 6 Banks
1. RS Options
2. Convenience Options
3. Security Options
4. System Behaviors
5. Output Config
6. Input Config
Programming now uses Prog button and Brake to select banks, feature, and options.
Enter programming with Ignition On/Off and valet 5x
- System will confirm, with 2 chirps
- Ignition back On IF brake requires ignition On for operation
Use prog button to select desired feature bank
- System will respond with chirps to correspond to selected bank number
- Chirps will repeat after ~2 seconds delay
Press brake to confirm selection
- System will respond with 1x chirp
Use prog button to select desired feature
- System will respond with chirps to correspond to selected feature number
- Chirps will repeat after ~2 seconds delay
Press brake to confirm selection
- System will respond with chirps to indicate current option setting of selected feature
Use prog button to select desired option within feature
- System will respond with chirps to correspond to selected option
Press brake to confirm selection
- System will respond with 1x chirp and return to feature selection in current bank
- Pressing Brake again will go back to the bank selection option
Feature Reset - Turn the ignition "on" then "off", immediately press the valet button 5 times. After long siren chirp/horn honk press and hold the Brake Pedal for >2 seconds. The system will chirp once and exit programming with all features set to OEM defaults.
New 80 Series Hardware
Non-blade control module (AL-80 / RS-80)
Same 6-pin main harness pinout as 70-seroes with adjusted wire gauges
- Red/White is now Red/Black
Includes single analog sensor port and door triggers in sub harness
New 4-pin harness w/ (+/-)P/L, Ground, and Siren
New 12-pin harness with 22AWG wires for all inputs and low current outputs
New antenna port is not 4-pin iData connector on side of module
Door lock port, Green & Black data ports, and Red RS output ports are all carryover from 70-series
===Blade control Module (AL-80-B / RS-80-B)===
Same 6-pin main harness pinout as 70-seroes with adjusted wire gauges
- Red/White is now Red/Black
Includes two analog sensor ports that are now independent zones(1 - White / 1-Yellow)
New 4-pin harness w/ (+/-)P/L, Ground, and Siren
New 12-pin harness with 22AWG wires for all inputs and low current outputs
New 6-pin harness with 18AWG wires for Horn/Light flash relays input/outputs
New antenna port is not 4-pin iData connector on side of module
Door lock port, Green & Black data ports, Red & Blue RS output ports, and Blade connector are all carryover from 70-series
New Remotes
119-03 - One button 1-way in carryover case from 70-seroes
- New xASK logo replaces x433
- CR-2032 battery
1420-03 - Four button 1-way with new case design
- New xASK logo replaces x433
- Plastic case with metal trim ring
- Snap together case, no screws
- CR-2032 battery
1423-03 - Four button 1-way in carryover all plastic case from 70-seroes
- New xASK logo replaces x433
- CR-2032 battery
1514-03 - Five button 2-way with new case and screen layout
- New xASK logo replaces x433
- USB-C charge port
- USB-C firmware update capability