View source for OL-HRN-RS Harnesses


=TB Coverage=
TB-FM2 and TB-FM3 firmware can be used with the respective OL-HRN-RS harness. Other TB applications have been evaluated and none have been found to have sufficient coverage or compatibility. <br>
Instruction page showing harness modification needed is posted on [https://www.wiresheet.com/v3/install_guides/OmegaLink-Excalibur%20T-Harnesses/OL-HRN-RS-FM2-FM3%20WITH%20OL-MIB-KO.pdf HERE]<br>
=RS Coverage=
The following harnesses will have adapters included to utilize the OL-MDB-ALL with RS firmware.<br>
OL-HRN-RS-CH7 V2.0<br>
OL-HRN-RS-GM8<br>
OL-HRN-RS-FM8 V2.0<br>
OL-HRN-RS-NI8<br>
OL-HRN-RS-TL6<br>
OL-HRN-RS-TL7<br>
Note: On one RS FW compatible harness it has been found that the bulk head connector was still locked but pulled enough to have poor connection on data wires causing no OL-MDB-ALL programming<br>

=Not Yet In Production=
<br>

=Adaptor Harnesses=
OL-HRN-RS-PWR = Universal power harness (main 6-pin) for any brand remote start<br>
OL-HRN-RS-PWR-CST = Power adaptor harness to connect Crimestopper (G5 Only) remote starts to Omega T-Harnesses<br>

=FM8 V2.0 Mod=
OL-MDB-ALL w/o direct P/L Control.<br>
Cut the 6-pin off and splice one of the power wires into the 4-pin connector from the OL-MDB-ALL for power, Isolate the other power wire and the Pink of the T-Harness so it doesn’t short out. Us the ground but connector for Ground. This gets you RS with no direct P/L control (VERY LITTLE operational benefit) from the OL-MDB-ALL.<br>
<br>
OL-MDB-ALL w/ direct P/L Control.<br>
RS firmware does very little with P/L, most guys skip this with RS firmware) This would require you to use the P/L sub harness included with the OL-HRN-RS-FM8. On this harness there are 2 wires terminated with Red but connectors, White and White/Black. Connect the White to the Pink wire that was cut from the 6-pin. Connect the White/Black to with the Ground wire.

=Guide Updates/Corrections needed=
FM3 - Add 2019+ Escape diag<br>
TL7 - Types #5 for stand alone (page 54), correct Blue 3-pinb to show White to Ground (see type #6)