OL-HRN-RS Harnesses
TB Coverage
TB-FM2 and TB-FM3 firmware can be used with the respective OL-HRN-RS harness. Other TB applications have been evaluated and none have been found to have sufficient coverage or compatibility.
Instruction page showing harness modification needed is posted on HERE
RS Coverage
The following harnesses will have adapters included to utilize the OL-MDB-ALL with RS firmware.
OL-HRN-RS-CH7 V2.0
OL-HRN-RS-GM8
OL-HRN-RS-FM8 V2.0
OL-HRN-RS-NI8
OL-HRN-RS-TL6
OL-HRN-RS-TL7
Note: On one RS FW compatible harness it has been found that the bulk head connector was still locked but pulled enough to have poor connection on data wires causing no OL-MDB-ALL programming
Not Yet In Production
Adaptor Harnesses
OL-HRN-RS-PWR = Universal power harness (main 6-pin) for any brand remote start
OL-HRN-RS-PWR-CST = Power adaptor harness to connect Crimestopper (G5 Only) remote starts to Omega T-Harnesses
FM8 V2.0 Mod
OL-MDB-ALL w/o direct P/L Control.
Cut the 6-pin off and splice one of the power wires into the 4-pin connector from the OL-MDB-ALL for power, Isolate the other power wire and the Pink of the T-Harness so it doesn’t short out. Us the ground but connector for Ground. This gets you RS with no direct P/L control (VERY LITTLE operational benefit) from the OL-MDB-ALL.
OL-MDB-ALL w/ direct P/L Control.
RS firmware does very little with P/L, most guys skip this with RS firmware) This would require you to use the P/L sub harness included with the OL-HRN-RS-FM8. On this harness there are 2 wires terminated with Red but connectors, White and White/Black. Connect the White to the Pink wire that was cut from the 6-pin. Connect the White/Black to with the Ground wire.
Guide Updates/Corrections needed
FM3 - Add 2019+ Escape diag
TL7 - Types #5 for stand alone (page 54), correct Blue 3-pinb to show White to Ground (see type #6)